LIBRARY | START | BACK | NEXT 1-CNC Control - Point to Point The NC systems can be classified according to the structure of the controller (NC and CNC), the mode of the control (point-to-point versus continuous path), and the type of control loop (open-loop or closed-loop). The mode of control determines how the tool is controlled or moved through its motion to position, or along the cutting path. The point-to-point (PTP) control system is many times referred to as the positioning system. The primary function of the PTP control system is to move a tool from one point location to another specified point, generally to do hole operations such as drilling, boring, reaming, tapping and punching. The path the tool follows may be one of three paths, depending on the control being utilized: Axial Path - The tool moves in a right-angle path parallel to the two positioning axes, X and Y. In this mode, the controller commands the tool to first move along the X axis and the Y axis would not move until the specified X coordinate position is reached. Then the Y axis would move to its specified coordinate position. This is the slowest method because the axes are moved one at a time. 45 Degree Path - The tool moves at a 45 degree angle until one of the axes is lined up with the new position. Then the tool moves along that axes to the specified coordinate position. Initially, both the X and Y axis move simultaneously until one of the specified coordinates is reached, and the tool then travels in a linear mode to the specified coordinate position Linear Path - In this mode, the controller has the capability to synchronize the motion in both axes, X and Y, to generate a linear path. This method provides the quickest path from one point to another, but sophisticated equipment is required to coordinate the speed of each axis to maintain a straight line LIBRARY | START | BACK | NEXT