Boring on the Mill
Boring on the Mill
VMS Forum | Library | Start Page | Previous Page| Next Page


1: Using the Mill to Bore Using a machine to create (bore) various size holes.

2: The Offset Boring Head and Parts Discussion of the various parts of one common tools used in boring.

3: Boring Tool Setup Procedures for correct machine set up when boring.

4: Rough Cut The importance of pre-drilling

5: Finish Cut How the finish cut is affected by various adjustments, and how to achieve a finished cut

6: Spring back Explanation of the spring back phenomenon

7: Single and Multiple Stage

8: Special Uses of Boring Bars

9: Cutting Conditions How feed rate, coolant and tool points affect your work

label: boring on the mill, rough cut, finish cut, spring back, cleanup, multiple stage boring, uses of boring bar, feed rate, coolant