Machinery's Handbook - 8: Fits
VMS Forum | Library | Start Page | Previous Page| Next Page
WARNING: Machine tools present a safety hazard. Improper operation can result in severe injury. These topics are for non-laboratory study only and are not to be used in conjunction with the operation of any tool or machine described herein. Never use a machine tool without the supervision of a qualified instructor.
The specification on the other side of the shaft is 2.00 Class RC7 fit.

Find the table for American National Standard Running and Sliding Fits (ANSI B4.1-1967, R 1987)

For a shaft of 2 in diameter, the tolerance is from -5.8 to -4 thousands of an inch.

The diameter must therefore be turned to:

2-.0058 = 1.9942 minimum

2-.004 = 1.9960 maximum

VMS Forum | Library | Start Page | Previous Page| Next Page

label: machiney's Handbook., blueprint, steel properties, speed and feeds, threads, measuremennt, over wires, press fits, slip fits